|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Braze a Block or Weld?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Russ on December 15, 1999 at 22:25:11 from (148.183.75.63):
In Reply to: Re: Re: Re: Re: Re: Braze a Block or Weld? posted by Burrhead on December 15, 1999 at 21:27:37:
Your right Burrhead, we are talking about "sealing" a cracked block. I have to admit that I have never tried to weld a block either. Just kind of got carried away trying to make others less experienced than yourself, aware of the need for pre and postheat in general terms of welding cast iron or cast steel.I think it`s also important to note that if the block, or head, or whatever, happens to be aluminum, you can almost gaurantee that you won`t get an acceptable weld without preheating to about 500 degrees F, or when spit bounces off in little balls. All in all it seems to me that if heating is good for strength type welds, maybe it would lessen the chance for inclusions or pin hole leaks. Can`t argue with your success though. I truly don`t mean to offend anyone, I`m just hear to learn some, share some, and have a good time.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
