You never did say what tractor you were trying to put this Cummins motor in. There is a company out there, I'll try to find it, that will sell you the engine mounts, a different hood, and a different grill piece for the Deere articulated 4wd tractors to put a Cummins in there. In a 2wd or an MFWD tractor the 8.3 C-Series would be a whole lot more logical to use, that is what Case uses in there 7000 - 8000 and now MX series tractors and they cranked that thing up to around 300 hp give or take. Now they are using the 9.0 C-Series with the emissions choking them down. If you really want a Deere with a Cummins in it go buy an 8960 which had the Big Cam IV or an 8970 which had the N14. Make it an animal you could modify it to around 600hp but that requires pump, injector and piston changes. You could pull the factory engine out and install an N14-600 in there or even better yet put the ISX-600 if you want to spend money.
If you have enough time, patients and money anything can be done. It's just nuts and bolts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.