Posted by Crazy Horse on November 27, 2007 at 09:14:51 from (64.42.242.39):
Got a question here about a battery charger. I have a twelve volt, 2 amp battery charger that I use for occasionally charging up small 12 volt batteries that are not used through the winter. Batteries for quads, motorcycles, etc. Anyways, this charger seems to work and keep the batteries charged. But it doesn't seem to put out what it says on the charger. It says it's output is 12V and 2 amps, however when I plug the charger in and check it's output by itself, it only puts out about 3.25 DC volts. When I attatch it to a battery (which is reading 12.39 volts alone without the charger), the reading jumps to 12.46 volts. Can anyone explain this strange occurance. Other (higher amperage) chargers I have seem to put out the stated volt value when tested alone and plugged in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
