Posted by Don-Wi on November 27, 2007 at 00:23:32 from (69.217.52.126):
I used a small drill to put a hole through my thumb nail tonight at work after I smashed it a little. At first it didn't hurt so bad, but a few hours later it was starting to really throb...
Went to the tool room and grabbed a small drill (maybe .047 dia, I forget) and twisted it on & off whenever I had a chance until it finally broke through. Good for short term releif but now it's back to throbing. Oh well, in another couple days it'll feel better again....
Aint the 1st time I've drilled a hole in my thumbnail, but I coulda swore that last time it felt better a little longer atleast....
Sometime it'd be fun to have a doctor laser it, but for now the drill is cheap and probably still faster than going to the hospital and waiting...
And for the record, I aint ever gonna try a needle. Just ain't gonna do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
