Posted by NE IA on November 21, 2007 at 16:44:42 from (12.215.72.189):
In Reply to: Cutoff wheels posted by Nedd on November 21, 2007 at 09:55:01:
You are welcome to use my jig if you live near NE IA, no charge. It is a tripod with big slotted chanel iron, and big all treaded bolts that go under the rim. It has a large cone in the center to center the wheel. A lomg 1/4 inch rod adjusts outward to the outer edge of your spokes with a washer attatched to hold the cutting torch tip, thus a perfect circle / fit.
The old guys told me that you weld every spoke except the last one, then take a break / let it cool down, then weld the last one, otherwise the weldes will break.
Sorry, I could not explain it better. I purchased it at a auction thirty years ago, and was advised it was a dozen different things after I purchased it. I purchased it very cheap, and was a factory machine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.