Posted by Don Wadge on August 25, 2007 at 09:10:11 from (204.112.131.55):
In Reply to: stuck ih engine posted by javan on August 24, 2007 at 19:45:41:
Well some say WD40 is garbage but I've had good luck with this method. Put at least a cup of WD40 (maybe PB Blaster or Kroil is better, a product called ReleaseAll would be good) in each cylinder. If the engine doesn't have a block heater you'll need one on it. Make sure the engine is full of coolant. Plug it in for a day or two, then unplug it for a day then plug it in again. Do this for about a week or longer. I've done several tractors this way. When the coolant heats up it will expand the cylinder wall before it heats the piston. This allows the WD40 to seep into the piston/cylinder wall area and break down the rust. This is why you need to repeatedly heat and cool the engine. The continual expansion and contraction allows the WD40 to penetrate. Then try to turn the engine. I've done this by removing the starter and using a prybar on a ring gear tooth (be careful here not to over-do it). It's best if you can get a pipe wrench on the front crank pulley. You also need to work the engine in both directions. Sometimes they come quite easily and sometimes more patience is needed. This method is where you start. If you don't succeed then pull the head so you can tap the pistons with a block of wood between. The prvious scenario will help much even if you have to remove the head. Once the head is off you will see the extent of your problem. If the cylinders actually got water in over a period of time there is not much you can do but tear it down. I would not recomend using diesel fuel and certainly never brake fluid.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
