Tractor Talk Discussion Board |
OT: '73 Chevy C-30 Dump Truck Hydraulics (again)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Blue3992 (N Illinois) on July 02, 2007 at 19:49:31 from (172.163.247.18):
Thanks to all for advice on getting a control cable for the hydraulic pump. I called around, and the good folks at Mark's Machine Shop in Sycamore, IL set me up with a control cable and all the hardware. Now that I got the hydraulics working, how do I check the fluid level, and how do I add fluid? I assume it just takes regular old hydraulic fluid. I couldn't find a fill plug anywhere underneath the truck. When the dump bed was raised, I thought I saw what might be a fill port, but I wasn't about to go climbing under the raised bed. Any suggestions? If it helps, the pump has a number cast in it--1016495D
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|