Tractor Talk Discussion Board |
Re: OT - Does anyone know how to tap a water spring?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on June 25, 2007 at 20:20:03 from (205.188.117.71):
In Reply to: OT - Does anyone know how to tap a water spring? posted by Todd in SE Ohio on June 25, 2007 at 14:30:47:
We had a water problem at our place where the horses are, knowing the water table and or springs in the shale, was not that deep, due to the geological structure under the ground, we set a round pre-cast concrete basin, I'd have to look at the photos, but I think it was 3 sections deep, 2 were perforated, like a drywell, the bottom solid, I wrapped the perforated sections with filter fabric, then backfilled with crushed stone, clean potable water drains into the bottom section, where I have a screened inlet, I ran black polyethylene water pipe to the barn a few hundred feet away, where the pump is, and it's worked great for a reliable water source. The were pumping out of the pond before that, not so good water.
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|