Tractor Talk Discussion Board |
Re: 601 questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by john in la on June 23, 2007 at 21:00:53 from (70.156.103.170):
In Reply to: 601 questions posted by Bigramjack on June 23, 2007 at 17:24:01:
The 631 and 621 were stripped down versions of the 641. It is in the workmaster class. Yours was built in Dec of 1959. The 631 did come stock with a 134 cu. in. gasoline; LP gas; or 144 cu. in. diesel engine; 4 speed trans; hyd system and 3 point hookup but that is about it. No PTO; proofmeter; temp gauge; drawbar; lights; tools or tool box. All of these items were options so your tractor could have none or all of these items. It should look like this....... (Thanks to Craig from NY for the use of his picture)
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|