Tractor Talk Discussion Board |
Re: John deere 60 carburetor 1952
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pappy on May 29, 2007 at 22:38:21 from (152.163.100.14):
In Reply to: John deere 60 carburetor 1952 posted by Steve Heier on May 29, 2007 at 19:54:48:
You mention two carb adjusters, so I will assume you have the early 60 with a single barrel carburetor. If so, the outside needle (left) should be open abour 1.5 to 1.75 turns to get it started. The inside needle (Right) should be open about 1.25 to 1.5 turns. Once it is running, you can re-adjust them to get best performance. The idle needle (left) is adjusted with the engine running at a fast idle. (no load) Adjust to get the smoothest performance. The load needle (Right) will have to be adjusted when you have a load on the tractor. That big nut on the bottom is just to hold it all together. Most likely, you will have to do some cleaning to get it to run right.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|