Tractor Talk Discussion Board |
Re: SAVE THAT TIRE!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by buickanddeere on May 29, 2007 at 20:26:47 from (216.183.144.41):
In Reply to: SAVE THAT TIRE!!! posted by Bruno45 on May 29, 2007 at 14:30:51:
I seen a tire one tire that had a sidewall hole ripped through the cords large enough to wiggle one's hand through. The owner actually stitched the rip together with stainless wire intended to safety lock nuts etc with on aircraft etc. A boot was placed on the inside of the tire and the tractor was used for years. Miller Tire also sells a two part cold rubber patch gap/gouge/hole filler.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|