Tractor Talk Discussion Board |
Re: JD 1360 Discbine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on March 24, 2007 at 11:05:19 from (142.177.6.10):
In Reply to: JD 1360 Discbine posted by Wet in NY on March 24, 2007 at 09:04:33:
No. Well, yes, mabey. I've got a 1460 which is the same mower with rollers instead of flails. I run it on a NH TS90 which is supposed to make 77 hp. Also on a 7710 which is turning 100+. On the hills, in a heavy first cut, the TS90 is lugging. The 7710 is lugging for that matter, but holding speed. The TS is geared down. It's also enough mower to throw those tractors around on the corners when you're moving.... anf they're both ballasted to over 11500# So.... 60 may run it slowly if things are just right, but it's really going to punish the tractor. If it's a small frame tractor without the weight of the TS or 10 Fords, it's going to get thrown around..... It wouldn't be me running it with 60. Beyond that, check that the bar is in good condition. Grab the discs and see if they're tight. Side play isn't good. Look for rock damage, etc. Those are the big things. Rod
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|