Tractor Talk Discussion Board |
OT, boat engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim, Ohio on March 09, 2007 at 08:33:56 from (128.146.239.246):
Hello Everyone, Last year was my first year of boat ownership. I followed directions for winterizing my outboard engine by changing the oils in the transmission (lower unit) and the engine itself. Then, I ran some stabil through it. Finally, I fogged the cylinders and put it to bed in the barn. What I was wondering is if I should once again change out the engine oil before beginning to use it this spring? Does enough water vapor form from condensation in cold storage to cause problems? Or, am I good to go for the season without any additional service? Thanks for your input. Tim, Ohio
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|