|
Tractor Talk Discussion Board |
Re: What size tire chains do I need?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jared in wi on March 05, 2007 at 17:20:28 from (69.179.68.239):
In Reply to: What size tire chains do I need? posted by SDE on March 05, 2007 at 16:58:59:
first thing i would do is get the latches working properly. spray some penetrating oil on them wd40 will work too. then i would lay them out and nice and neat, and make sure the chains are not all twisted up, make sure all the links lay nice and neat. then look for the side that has wear on them, and put that side out, if both sides have wear, pick a side. then grab one side of the chains and throw them up and over the tire. get it straightened out, and then drive the tractor forward or back ward a few feet and hook both ends of the tire chains. i usually like to do the inside one first, and then the outside one, because the inside one is harder to get to. after you get get one side installed, do the same for the other side. then drive it around for a 5-10 minutes , and retighten them. when you stop, make sure the conectors are on the rear side of the tire and near the ground, that is where all the slack is, when you are going forwards.I like to get them tight enough that they do not hit the fenders and make a bunch of racket. if you do not have fluid in the tires you may be able to jack up the rear end of the tractor and let some air out of the tires, put the chains on, and then pump them back up. that way they will be nice and tight. jared
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
