Tractor Talk Discussion Board |
Re: Repowering tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on February 23, 2007 at 20:32:47 from (142.177.6.68):
In Reply to: Repowering tractor posted by 730 on February 23, 2007 at 09:26:34:
If you only kenw it, there's probably a kit to do it. County, Roadless, and numerous others in Europe specialized in dropping the 2700 series of Ford industrial engine in the Ford 5000 chassis. The biggest hitch was supporting the engine. It needs frame rails, or a cast hull to support the tractor. That block was not intended to be "stressed". I'm not sure if it was 363's they used, but they often called them "Dorset" engines, or 2715E's I think.... I'm not sure if the 363 was a 2700 series, or the older industrial engine.... I guess you could fit it to a 9600 too, but it might be smallish? An idea anyhow. Rod
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|