|
Tractor Talk Discussion Board |
Today's old-time ice harvest - warning- many phot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on February 03, 2007 at 12:48:13 from (66.218.15.142):
Somebody on this forum - a few weeks back - asked about storing winter's cold and using it in the summer. That's basically what we did today. The water-powered (and steam) grist and saw mill that my wife helps run had it's annual ice-harvest today on the mill pond. It's all pretty much done the way it was 150 - 200 years ago. It gets stacked in the ice house packed in saw-dust, and this summer they will use it - mostly to make ice cream. The mules pull the ice-marker/scorer. Then the ice gets sawed by hand. There's also a Ford Model T powered ice-cutter. Ice chunks get pulled up the ramp onto the loading dock. The draft-horses pull the loaged ice-sled to the ice-house.
The harvest was initially cancelled two weeks ago - since we had the warmest winter on record. Then - went to below zero, off and on. We had 18 below zero last week and the ice is now 8" thick. 4 degrees F. above this morning, and warmed up later to 18F.
The one dark photo was first thing this morning. I was trying to get a shot of the moon - and a plow truck came by with flashers on (and got stuck for an hour).
The mule scoring ice is from Erie-Canal village-museum. The big holstein is an ox in training.
The happy little kid is my three-year old. He got cold in the snow and found a dry spot under a barn-eave by the mill's big steam-engine boiler. [IMG]http://i104.photobucket.com/albums/m162/jdemaris/Ice%20Harvest%20Feb%202%202007/first-morning_light_plowtruck1.jpg[/IMG] 
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
