Tractor Talk Discussion Board |
Re: 1941 A John Deere Govoner Problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by luckydog on January 01, 2007 at 10:31:30 from (216.170.157.222):
In Reply to: 1941 A John Deere Govoner Problems posted by Rob Hartman on January 01, 2007 at 07:40:12:
Rob-- Just a thought, on top of your gov. housing where your linkage is there is a gov. spring that is held to the gov. arm. Your spring is bolted to the arm with a bolt and a lock nut. Loosen that nut and make sure that the bolt is all the way in and tight then tighten the nut. If that bolt is alittle loose or not seated that may be your problem. Just a thought. Luckydog
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|