Tractor Talk Discussion Board |
1941 A John Deere Govoner Problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rob Hartman on January 01, 2007 at 07:40:12 from (74.34.89.181):
Hi guys. I've been reading alot of your posts. I really get a kick out of Allen and Gary, you guys make my day. I've been having some trouble with my govoner. I have a 1941 A with a Power Block. I have totally rebuilt everything on this tractor. The only piece I did not replace in the govoner was the bronze collar that slides on the shaft. I cleaned it up with some emery cloth and it looks fine. I've done all the tricks with the linkage and my govoner is lazy. It has to really be under a load for it to come alive. It is slow reving up, and wants to overrev abit. If you stand on the brakes it will come on, if you put it on the dyno it will come on. I put 3-14's behind it and drop it in the ground and it just idles down but still pulls, the govoner is just not working. It pulls over 60hp on the dyno. I'm out of options on this if somebody has any ideas I sure would appriciate it before I have no hair left. Thanks
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|