Tractor Talk Discussion Board |
Re: hay equipment questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JMS/MN on December 24, 2006 at 11:33:09 from (204.73.106.15):
In Reply to: hay equipment questions posted by old fashioned farmer on December 24, 2006 at 10:44:30:
Check Erskine Mfg., Erskine, MN. Also Loyal Barn Eq.(?), Loyal, WI. I made my own in-barn conveyor in the early 70s. Several sections bolted together, later replaced the outside elevator with a similar HM one, all driven by the 1 1/2 hp motor in the haymow. Outside conveyor was 1 inch pipe frame, inside one was 1 inch angle frame. Sliding tip-off sat on top of the inside conveyor, could be slid anywhere along the conveyor. Flat detachable chain ran through two sprockets on the tip-off, and I used a flat steel plate, quarter inch by four, about three feet long, hinged at the bottom, to tip off the bales. One plate on each side of the chain, raise one plate to lift the bale as it advances, tips it off to the other side. Could post a picture of it if you want it.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|