Tractor Talk Discussion Board |
Re: Buzz Saw Blade Speed?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on December 13, 2006 at 12:16:43 from (199.17.6.122):
In Reply to: Buzz Saw Blade Speed? posted by Hick on December 13, 2006 at 10:52:25:
The flat belt should be running about 2500fpm This is pulley rpm times circumference. This speed is going to be approximate. The driven pulley should be in the area of one to 1'-3" in circumference to increase the saw speed to about 2000-2500 rpm. Our farmalls used a 2:1 overdrive ratio on a 24" saw. Pulley speed was ~1200, saw ~2400 rpm. All saws are dangerous and some can throw carbide inserts. The above information is best I know from personal experience. I would ask that you inspect the blade for cracks and defects befor operating, then while using it stand clear of the blade's plane of operation until its security has been proven. JimN
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|