Tractor Talk Discussion Board |
Hey Bob, others, block heater
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 1 Dollar on December 08, 2006 at 20:08:46 from (24.208.219.15):
How 'bout I plan on a hybrid of two of the ideas... 1. 1/2" short nipple or however long as necessary, 2. Connector of some king with the 5" long 1/2 NPT screwed into that. I have about 3.75 inches into the head before I hit any metal, 3.5 to be safe. So if the nipple apparatus gets me 2" than that leaves me 3" still right up in the head where it will do the most good. What do you think, hope the paint creation is understandable. Thanks
Replies:
- Re: Hey Bob, others, block heater Ken Thies 17:39:17 12/09/06
(0)
- Re: Hey Bob, others, block heater Ken Thies 13:00:25 12/09/06
(0)
- Re: Hey Bob, others, block heater Get Rad Hose Heater 03:12:37 12/09/06
(0)
- Re: Hey Bob, others, block heater Bob 22:21:32 12/08/06
(0)
- Re: Hey Bob, others, block heater 1 Dollar 20:30:16 12/08/06
(0)
- Re: Hey Bob, others, block heater Jerry/MT 20:25:09 12/08/06
(0)
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|