Tractor Talk Discussion Board |
Re: PM'ing a furnace in my shop
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scot r Maxwell on November 20, 2006 at 14:13:14 from (63.224.181.102):
In Reply to: PM'ing a furnace in my shop posted by David McDan on November 20, 2006 at 09:37:20:
Make sure power is off first ! Be safe ! If you're not carefull you can lose your eyebrows !If you can reach your burners, clean them with a wire brush and blow them out with an air compressor they will burn orange for quite a bit while burning dirt and dust when you first fire up the furnace. Watch the burners, blue with a little yellow orange candle shape flame is best, if it's more whitish yellow, burners need adjusted. watch burners when blower engages, if burners get eradic when blower engages, large cracks could be the culprit... when someone finds a crack it needs to be substancial to cause problems, however, cracks don't get better.... if the cavity around the burners (heat exchanger)is full of suet clean them well !! blow them out good! always oil the blower. tap the pilot assembly while pilot is lit and blow out with air compressor and relight pilot, unless it's electronic spark or hot surface ignition. good luck.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|