Tractor Talk Discussion Board |
Welder charging system.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by doogdoog on October 16, 2006 at 23:58:52 from (75.80.223.143):
Aloha, I have a Lincoln welder and have a question on the charging system. The regulator has 1 terminal in the back that goes to the A terminal on the motor/generator (used to start the engine and chagres the batt). There are 3 terminals on the bottom of the regulator marked L (tech said that is used for the idiot light if wanted), F goes to F on the motor/generator, and B goes to the battery. Ok now the question, if I wanted to polarize the generator, how would this be done? I saw one article that says to momentarily place a short jumper wire from the Batt terminal to the Gen terminal of the regulator. What would be the gen terminal?? Would that be the terminal in the back of the regulator that goes to A on the motor/generator?? TIA Mahalo, doogdoog
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|