|
Tractor Talk Discussion Board |
Hey Allan! a few more pics of the 3000!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on September 17, 2006 at 20:29:32 from (64.12.116.74):
My girlfriend took a few action shots today while I was opening up the next feild. Just yesterday I finished putting new gathering chains on the head and I had the 2 sprockets that come out the side and drive the roller. I took the old ones to the shop I used to work for, then they cut off the bad ones and welded on new for $45. I've done many sprockets like that when I worked there... Anyways.... I also touched up the knives again yesterday and re-adjusted the shear bar. It's really amazing how many extra horses just a few thousandths of wear will take to run... First I finished a feild I started last Sunday, and after 9 loads it was starting to wear just a little so the husks weren't always being cut as short as the rest of the corn. I had to pull back to 2nd direct/sometimes under last week. Last night I left it in over the whole time and it cut EVERYTHING the same length. Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
