Tractor Talk Discussion Board |
Re: Farmall Cub Engine Block
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on August 31, 2006 at 20:45:17 from (4.154.243.214):
In Reply to: Farmall Cub Engine Block posted by Ed Blevins on August 31, 2006 at 18:18:25:
This comes up several times a year on the Farmall board. The most often neglected plug is the one in the tappet chamber. Pull the stamped plate behind the carb. At the center of that opening between two tappet bores you will see the hole. The next neglected hole is by the camshaft at the front. It will be alot of work to replace that one. Can't remember if the back of the block is drilled but should be easy to find. It will be near the camshaft. The other holes are external. One near oil filter. The other is lower right side of block near bell housing flange. Do not start a Cub, or any engine, without pressure testing oil galleries with oil.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|