Tractor Talk Discussion Board |
Re: ALLIS CHALMER TIRE QUESTION
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by wdtom on August 28, 2006 at 18:02:30 from (155.212.223.59):
In Reply to: ALLIS CHALMER TIRE QUESTION posted by bobby macdonald on August 28, 2006 at 09:15:40:
HI Bob, It's Tom, Vaughn's friend. The parts book also says they were only an option for WD-45s. It doesn't say anything about being an option on the WD. Now I know they are basically the same and the parts will fit. However if you are at a pull and someone wants to bust your ballls, and they know, well here is a way if you have a WD, andnot a WD-45. Now how much of a 45 is a question too. The rear end with the serial no. would be a good start, as would a curved shift lever (later WD and all 45s had it, is a constant mesh transmission as opposed to sliding gear), and 45 engine (no side plate on the right side. I still question whether there would be enough power for the larger diameter wheel in a pulling situation. Talk to you sometime, you going to Woodstock with Vaughn? Planning on being there with my WD. Tom
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|