Tractor Talk Discussion Board |
Re: Hope This Works!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don L C on August 21, 2006 at 19:07:56 from (24.166.244.128):
In Reply to: Hope This Works! posted by Allan In NE on August 21, 2006 at 17:37:02:
I think it could work.....after you get them hooked the way you said slowly pull them straight ahead and then extream left and back, then right..... I am thinking maybe you could mount a 2" hitch ball on the tail of each rake.....take a straight ahead measurement across between the two balls......weld or bolt a hitch coupler on a piece of 2" heavy wall pipe.....if they pull and swing togeather this will stabilise the tail ends.... length from hitch pin to wheel spindle may have to be the same on both rakes.....give it some though.....Don L C
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|