Tractor Talk Discussion Board |
Re: Connecting Int'l 2050 Loader
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Shep Va on June 29, 2006 at 05:41:34 from (68.152.9.254):
In Reply to: Re: Connecting Int'l 2050 Loader posted by in-too-deep on June 28, 2006 at 16:20:01:
You are correct in-too-deep, the plug you have to put in is in the end cab, you understand what I am talking about. You guys cannot see the plug unless you take the end off the tractors remotes. You plumb the hoses the same way fromt the outside, it is just that plug that blocks the flow and forces the oil out toward the loader valve. Without this plug the oil will still flow to the loader controls, but it will not have pressure. I went through the same thing with the 684 earlier this year. I really dont remember what hole gets plugged. I want to say it is the bottom hole away from where the hose hooks on, but I cant say for sure. There is a part number for the endcap with the plug in it, I would think the CIH dealer could bring up a picture of it and tell you what hole you need to plug. I bought my endcap with the plug in it from Hoober INC. in PA. Maybe they can tell you if you call them. www.hoober.com Good luck.
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|