Tractor Talk Discussion Board |
Re: 3 point vs. Pull?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt Kane on June 23, 2006 at 18:39:38 from (70.104.109.112):
In Reply to: Re: 3 point vs. Pull? posted by J Schwiebert on June 23, 2006 at 18:10:54:
Its a Diesel with 3 3/4 inch bores. The man who rebuilt it said close to 50hp. It has the external control valve, So if there is a valve in there to clean where is it located. It will partially raise when throttled up, but will not lift any weight. I dont want to tear into the hydraulics under the seat yet. If you know the horsepower based on the bore size, rest is stock let me know what the hp is. Thanks
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|