Tractor Talk Discussion Board |
Re: Ammeter wiring
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on June 22, 2006 at 06:50:57 from (66.244.90.5):
In Reply to: Ammeter wiring posted by Dennis Devine on June 21, 2006 at 21:40:14:
Dennis, converting the battery n charging system from 6 to 12 volts shouldnt affect the ammeter n she ought to still work, its a current through it sensing device NOT a voltage device. Soooooooooo other things that can affect it are if you changed ground polarity???????? If you did its wires all need reversed or it will read bass ackwards. If its wired correct if you switch on lights or ignition not running it should swing over to - discharge but then swing to + charge when running ifffffffffff shes charging Sooooooooooo is she charging??? you know???? The ammeters SUPPLY terminal usually has but ONE wire and thats to the hot ungrounded battery post often via connection at a starter switch/solenoid where the big battery cable attaches. Its other LOAD terminal is what feeds loads like lights n ignition PLUS it wires to the BAT terminal on a Voltage Regulator so it can accept the gennys charging current. BOTH ammter terminals PLUS the BAT terminal on the VR should ALWAYS indicate hot battery voltage if alls wired correct and working. John T
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|