Tractor Talk Discussion Board |
Re: Don't know about you guys, but
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy as in Randy-IA on June 18, 2006 at 11:32:02 from (209.152.95.61):
In Reply to: Re: Don't know about you guys, but posted by JohnDeereGreen on June 17, 2006 at 16:09:08:
I think the bigger they are the slower they have to run . It takes a long time to stop and turn around a 1000lbs of piston and con rod . At the power plant in town we did some work a number of years ago and I saw the largest diesel engine I've ever seen in that building . I don't remember how many cylinders or the horsepower but I do remember being amazed at how slow it ran wide open . The specs were on the wall . It IDLED at 67 rpm and ran wide open under load at 180 rpm . They had a piston from it in the lobby and it was close to 4 FEET in diameter . The con rods are exposed with an open crankcase . I'm guessing it was about 18 - 20 feet tall and 35 - 40 feet long . And the muffler is about the size of a pickup truck . I know it's not an unusual engine for powerplants but it was the largest one I've ever seen . You really can't even hear them running outside it's so well muffled since it's right in town . Quite interesting . ...Randy
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|