Tractor Talk Discussion Board |
Allen/ 4L80E problem, kind of long-winded
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by muggsw6 on June 16, 2006 at 06:27:17 from (4.158.225.160):
Allen, thanks for the suggestions, I couldn't help but think along the same lines. Glad to hear it from someone else. The local"expert" suggested that the converter was bad, I wasn't buyin' that! This trans was out of another truck that was in an accident, had been overhauled 3,000 miles before, bought from a friend of mine. The trans was out of this truck when I bought it. The harness in the old (mine) was swapped into the replacement trans,(Jeez, that sounds complicated) as it was broken in the wreck. As an aside, the truck was purchased from a VERY large seed company who did nothing but pull a 30 ft. GN trailer with it. The truck was set up to pull w/vacuum over hyd brakes, very hd 5th plate etc., But NO TRANS COOLER????? The trans that was out of it was the 2nd replacement and was completely fried, with only 77,000 miles. I guess they must have saved a couple bucks by buying it that way????? Penny wise, pound foolish??? Anyway, I'll check out the connector this weekend. Thanks Allen,Mark
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|