Tractor Talk Discussion Board |
Re: OT: Furnace Blower Problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Buzzman72 on June 05, 2006 at 08:30:33 from (4.89.128.57):
In Reply to: Re: OT: Furnace Blower Problems posted by buickanddeere on June 05, 2006 at 07:18:54:
If set to the proper voltage scale, I didn't realize you could smoke the meter. If it's not good for the range it says, why do they put that range on the meter to begin with? Now, I could understand blowing the internal fuse if the amperage was too high; but if the DVOM is set to the proper scale, why would it get fried? I don't know much about capacitors on these motors; I just know mechanics. Wife THINKS that, because I'm a man, I should know everything there is to know about plumbing, electrical contracting, roofing, concrete, construction, and septic systems...so obviously, since I've never worked in ANY of those fields, and never had training in any of them, I'm a deficient member of the species. Maybe I'm not to swift on this troubleshooting thing...but I figured that, before I started worrying about capacitors, maybe I oughta check to see if there is any voltage going to the motor to begin with. Is that the wrong way to proceed? I just figured that, if the electronic control module isn't switching power to the blower motor, the problem might well be in the electronic module...and if there IS voltage to the motor, THEN I can investigate why the motor isn't running. Or is my logic faulty in this line of reasoning?
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|