Tractor Talk Discussion Board |
Re: 1971 FORD 2000 GAS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JDknut on May 31, 2006 at 13:45:24 from (152.119.204.83):
In Reply to: 1971 FORD 2000 GAS posted by SKFOOTER on May 31, 2006 at 12:37:54:
Depends on the quality and thoroughness of the "restoration". If they really did a complete mechanical overhaul-engine, clutch, trans, etc with the documentation and reciepts, and a factory quality paint job, and the tractor has a lot of factory options and is relatively low houred (this is hard to prove), then that is not a terrible price, but if they only threw in a carb kit, a cap and some plugs and slapped on some spray paint, then that price is a taste high. A lot of people wouldn't want to spend that much money on a gasser that they were going to use every day. Just my $0.02. check Fastline and other machinery sales sites and references to see what tractors like that are going for.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|