Tractor Talk Discussion Board |
Re: Govenor Farmall H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RustyFarmall on May 30, 2006 at 07:46:35 from (207.32.13.249):
In Reply to: Govenor Farmall H posted by Delbert Doty on May 30, 2006 at 07:20:26:
Most likely the bearings will be the most expensive part, but you probably don't need new bearings. The governor spring is usually what causes problems, so you will need a new spring. Also, the holes that the spring hooks into get worn and egged out. You can weld the holes shut, and the drill them out to the proper size, or find a shop that will make some bushings for you and put bushings into those worn out holes. There is very little else that causes problems, just clean everything real good and make sure everything moves nice and free and easy and you should be good to go.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|