Tractor Talk Discussion Board |
Re: how fast in 4X4?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by toolman on May 18, 2006 at 19:02:08 from (24.66.64.56):
In Reply to: how fast in 4X4? posted by Tim Shultz on May 18, 2006 at 18:25:08:
I can,t tell from the picture for sure but it looks like you have warn hubs on that,(meaning you have to turn them in by hand then go inside the cab and shift it into 4x4) if that,s the case then just shift it outa 4x4 in the cab back to 2 high and leave your hubs in and it won,t hurt anything , might cost you a bit more in gas but it is good to run them with the hubs in some to get everything nice and oiled.I f it is fulltime 4x4 meanting hubs can,t be turned by hand and you only have to shift in into 4x4 range inside the cab , then i wouldn,t run it very fast, even when they were new they didn,t stand up to that too very long, now that,s it,s 33 years old it might be getting a might bit tired and decide to pop the transfer case or the front axle gears or both.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|