Tractor Talk Discussion Board |
Starters and Alternators....
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by davpal on May 16, 2006 at 22:45:50 from (216.93.97.5):
Hello People, I have to give a good company a plug here on the message board because they deserve it. I was having trouble with the starter on my 3208 cat in my white 4-150 and I found a place on the net called "Nations Starter & Alternator". They are located in Cape Giradeau Mo. Their Phone number is toll free 1-888-334-2632. These people were great and the shipping was lightning fast. I ended up getting a brand new Delco 40 MT replacement starter complete with new solonoid for $259.95. It is very heavy (70 lbs) so it cost $30 dollars to ship. This starter is made in the USA by Wilson Electric and was heavier duty than the original Delco. It has updated brushes and insides and was built heavier although it was exactly the same dimensionally so there were no suprises when I installed it. I did have to turn the cast iron nose cone to the right position but it was very easy. I think I found my problem now because it fires right up every time now. (At least it has so far)! Mine was a 40MT with a clowckwise rotation and a 12 tooth bendix. They have a lot of different applications for many diesel trucks, pickups, tractors, atv, cars, and so on. I like it because they have new and also offered rebuilt for harder to get stuff. I could have gotten a nippondenso gear reduction unit for $499. I didn't but if I had a semi that got used 365 days a year I would have. These guys are really knowledgeable and instantly knew about my tractor and what fit it. It was refreshing to deal with a place that had it together like that. If you need a new or rebuilt starter for something I would look them up. I think they will do you right.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|