Tractor Talk Discussion Board |
category II pin diameters
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brandon1234 on April 23, 2006 at 16:48:40 from (12.47.142.254):
Hello, I have a question concerning category II pin diameters. I looked here http://www.ytmag.com/atrp/3points.htm and it tells me that the lower links are 1 1/8" and the upper is 1" I look at the ASAE standards and it tells me the lowers are 1 7/16" and the uppers are 1.25". I have a John Deere 4430 with a John Deer quick hitch that I just purchased. I have several implements that do not have the proper dimensions on them and I am going to weld up the connection points so that they will fit the quick hitch. My question is I don't know whether or not to use the smaller or larger pins. The larger pins will fit in the quick hitch, but nearly all of these implements had the smaller ones to begin with so strength is not an issue. I guess what I am concerned about is if I use the smaller pins, will the free play in the hitch be a problem?
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|