Tractor Talk Discussion Board |
Re: NAA transmission question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by souNdguy on April 06, 2006 at 06:29:53 from (12.65.54.39):
In Reply to: Re: NAA transmission question posted by Dudley Do on April 06, 2006 at 06:04:20:
No.. it wouldn't fit unless you were a machinist .. that is.. the massive amount of re-fitting it would require to adapt a 3spd 9n tranny to that tractor may cost more thant he tractor... remember... the 3spt tranny also has the pedistal to the steering column, and dash supports.. N have the rounded hoods and flat head engines.. NAA have the torpedo metal and an OHV engines. Naa sn will be on the angled boss aft of the starter.. or if it is an early 53, on the left front corner of the engine, near the manifold. 9-2-8 N will ahv ethe number on a 1x4 flat boss just below the head, left side of engine, aft of the oil filter canister.. Take a rag or toothbrush... that flat top tranny will have 1-4 and R imprinted into it. ( 9N tranny is dome topped.. not flat like an 8n / naa.. ) Soundguy
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|