Tractor Talk Discussion Board |
Re: Please help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on April 02, 2006 at 20:30:47 from (207.94.26.1):
In Reply to: Please help posted by rrs26ja on April 02, 2006 at 16:59:27:
Connect a test light between the side of the coild connected to the points & a good ground. The light should be lit when the points are open (connected to battery through the coil) and off (shorted to ground) when the points are closed. The light should pulse in time with the points when you crank the engine. You can also use an analog voltmeter if you don't have a test light. Don't use a digital voltmeter for a test like this, the integration time is too long to see individual pulses. Hard to tell from your description if you may have something in the points wired wrong, but if they aren't opening & closing properly you won't have spark. The moveable arm on the points is connected to a screw terminal mounted on insulating material. The copper band is probably the connection between the moveable arm and the terminal. The low side of the coil and the condensor are both electrically connected to the moveable arm. When the points close, the low side of the coil is grounded via the fixed contact. The top of the coil will be at battery voltage, unless you have a ballast resistor, in which case the top of the coil should be at about 1/2 battery votage when the points are closed (current being drawn through resistor) and battery voltage when the points are open (meter won't draw enough current to cause a voltage drop through the resistor) 8+ volts seems a little low, but may just be the battery voltage when its cranking. Keith
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|