Tractor Talk Discussion Board |
Re: sears craftsman model 131.96315
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rustyj14 on January 17, 2006 at 09:21:40 from (209.195.143.192):
In Reply to: sears craftsman model 131.96315 posted by new beginnings on January 16, 2006 at 22:10:16:
Look on the flywheel housing, the tin piece! on the side, rear, or near the rounded part over near the cylinder head are some letters and numbers. I.E.: Type, model, code, or words/numbers like that. You might have to sand thru any rust or scrape off the dirt. These are the numbers you must post here. The numbers you posted are the Sears mfgr. numbers, and only should be used for info on the mower itself, not the engine! Some of the older engines had an aluminum plate on the cylinder with the info there, and i have even seen a sticker glued on someplace, on newer engines, which soon becomes useless! Rusty
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|