Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: Water Well Problems 2


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Gary Schafer on December 25, 2005 at 09:01:05 from (71.57.149.211):

In Reply to: Water Well Problems 2 posted by john in la on December 25, 2005 at 06:56:11:

Hi John,

You didn't say what type well you have. Is it a sand point driven down? If so then you can't use a foot valve on it. The foot valve would break as you tried to drive the point.
The check valve at the top should work fine if you have no air leaks in the well pipe above the water table.

Your intake line from the well to the pump should not make a loop above the pump and down again. Air can get trapped in the loop. The best way is to come off the well with a 90 and go straight over to the pump.

If your check valve is leaking then the tank will drain down over a period of time but the pump will still maintain its prime and start ok as long as the tank doesn't go empty on you. Once all the water leaks down then it will also loose its prime.

If the tank is not leaking down but the pump is loosing its prime then you have a leak between the check valve and the well.
Did you change the point or well pipe recently?

Another problem may be the amount of lift you have from the pump to the house. You mentioned 220 feet. Is that horizontal or is part of that vertical lift? If you have a large vertical lift then the water in that pipe will provide back pressure and may be enough to not allow the pump outlet pressure to drop low enough to turn on. If so then you would need to change the pressure switch setting.

Prime the pump, get it working and watch the gauge to see where the pump starts and stops as water is run. Then turn off the power to the pump and open a faucet at the house and watch the pressure gauge to see how low it goes when there is no more water coming at the house faucet. That will tell you how much back pressure you have in the water line from vertical lift.

Regards
Gary




Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy