Tractor Talk Discussion Board |
Re: John Deer 4010 PTO Handle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by R. John Johnson on December 11, 2005 at 05:31:48 from (205.200.43.99):
In Reply to: Re: John Deer 4010 PTO Handle posted by dp in nd on December 10, 2005 at 16:57:19:
If you also take the top cover off the console, in addition to taking off the cover with the key switch, you should be able to view the whole pto linkage. There is a rod with a bent end that hooks into the pto handle. It then goes into the long adjusting nut, which connects to a rod which goes through the floor into the clutch housing. If memory serves me, the clutch is ajusted as follows. Position the PTO lever so the detent is holding it . This is neutral, just ahead of the brake position. Remove the cotter pin holding the rod to the handle. Ajust the rod in or out of the adjusting nut until there is 3/8" vertical free play to line up the rod with its hole in the lever. You lift the rod by hand until it feels resistance. The 3/8" will be above the hole. reinstall the rod in the handle and reinstall the cotter pin. If I have this wrong, someone will tell me. John
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|