Tractor Talk Discussion Board |
Carb help!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by INCase on November 09, 2005 at 04:58:16 from (209.221.240.14):
Help. I have a Case 800 tractor that I aquired a couple months ago. It sat about 6 months was run and sat for another 6 months. When I went to start it, the carb flooded and gas was leakingout between the air inlet and the carb body. I figured it was the float sticking so I bought a "kit" at Napa and cleaned and "rebuilt" the carb. The carb is a Marvel-Schebler TSX7?? model. I put things back together and turned on the gas no leaks but over night the carb started to leak again. It"s almost leaking worse than before and looks like gas is leaking from the slot shaped hole near the air inlet and is filling up the inlet area. Next. I was able to get the carb dryed out and put gas in the tank and got it to start (before it flooded) and run for about 3-5 minutes then it died. I was able to get it to start again but can only get it to run for about 30-60 seconds before it would quit. I tried ajusting the carb needle valve between tries with no improvement. What could be wrong here? THANKS for the help!!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|