Tractor Talk Discussion Board |
Re: Will straight pipe hurt motors??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on October 14, 2005 at 05:13:29 from (205.188.117.6):
In Reply to: Will straight pipe hurt motors?? posted by logan on October 13, 2005 at 19:54:20:
Yes, no, and maybe. First off, it's not back pressure that prevents valves from floating, it's spring pressure. The weaker the spring, the better the chances of valves floating at higher RPMs. The stronger the spring, the less chance, but the more wear and tear on the rest of the valve train (cam lobes, fulcroms, etc). Back pressure actually keeps the face and back of the valve at a more even temperature, which lack of can cause failure. Too little back pressure over time and will notice damage caused because the face of the valve is typically hotter than the backside exhausting the burnt gases into a cooler manifold, header runner, etc. As far as adding horse power, that can be true under the right conditions. Runner length and diameter directly affect both horse power and torgue. I can't count the number of times I've seen headers or open exhaust on an engine show a decrease of either horse power, torque, or both because the diameters were too large, the lengths were too short, or too long, or a combination of both. Chances are you're going to want to run a longer pipe because your engine is a lower RPM engine, and torque is what you're after. Is your engine normally aspirated? Turbo charged? What's your cam lift? It's duration? Straight pipes can be good, under the right conditions. They can be just as bad if aren't tuned to the needs of the engine, which should be tuned to your needs. The answer to your question as posed is yes, no, and maybe. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|