Tractor Talk Discussion Board |
Re: Will straight pipe hurt motors??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by onefarmer on October 14, 2005 at 04:02:36 from (216.93.96.13):
In Reply to: Re: Will straight pipe hurt motors?? posted by Mike Van on October 14, 2005 at 01:15:19:
Headers is a straight pipe. Actually what straight pipe refers to is the exhaust pipe that comes after the manifold whether cast iron or tube headers. What headers do is make a smoothflow for the exhaust. No sharp turns like with a cast iron manifold. Also in racing they are "tuned" meaning a certain diameter tubes at a certain length proven by testing to be optimum for the rpms and flow of the engine for maximum HP. If an engines mainly run at 4000 to 8000 rpm it would require a different size tubing for best scavenging of the exhaust than say an engine running 1000 to 3000 like your daily driver.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|