Tractor Talk Discussion Board |
Re: crankshaft driven hydraulic pump shaft
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kyler on October 13, 2005 at 13:39:57 from (152.163.101.7):
In Reply to: Re: crankshaft driven hydraulic pump shaft posted by rwp on October 12, 2005 at 20:32:50:
the shaft is 1 inche and the key way end is 3/4 it is 10 spline 17 1/4 inches long the parts came in and i put it back together sometimes ya just gotta make due when ya need to use it but the drive plate isnt messed up lucked out there i got some liquid steel and cover the shaft with it greased the drive plate so none would stick to it pushed it into to make some new splines and pulled it back out then let it set over night itll work for a while i would still like to have a back up thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|