Tractor Talk Discussion Board |
Briggs Stratton Model 5 S
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Irving Legate on October 10, 2005 at 06:19:00 from (65.96.242.5):
Need to know how to remove a broken leather points opening plunger from the recess in the back plate...approx. 1/4 of the plunger broke off in the recess...have tried a drill bit and dental pick to remove remaining portion and no luck. Any Suggestions? Is the removal of the whole back plate the only solution? I have loosened the 4 mounting bolts of the back plate, but the back plate will not come loose. What else could be holding the back plate? Is it possible a previous owner used gasket sealer to mount the back plate? Gentle prying of the back plate w/ bar did not loosen it. How much force will the back plate take without breaking the cast aluminum back plate?
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|