Tractor Talk Discussion Board |
Re: Ford 8000 power steering.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RodinNS on October 07, 2005 at 06:54:59 from (142.177.97.217):
In Reply to: Re: Ford 8000 power steering. posted by Ty Lee on October 07, 2005 at 05:37:53:
If the gears have started to cut the housings, then it's time for a new pump. That sounds like the case here, as you suggest that it works better at higher RPM's. Otherwise, there could be a malfunctioning relief valve or flow control valve. As Hurst has suggested, there could be a problem with the motor as well, but I have my doubts in your situation. The motors have a lot of small parts that make them look complicated, but in reality they are quite simple, and there isn't a whole lot to go wrong. To pressure test, you would need to "T" into the output line from the pump, then run the wheel over to the lock to make pressure, and see what it reads. This being done with warm oil. However, if you know the housings in the pump are worn, then that's as good a bet as any. I'd probably just buy a new pump. HTH. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|