Tractor Talk Discussion Board |
Re: water pump on a 1969 MF 1100
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JDMAN60 on September 19, 2005 at 13:13:18 from (208.251.230.34):
In Reply to: water pump on a 1969 MF 1100 posted by Jeremy Yandell on September 19, 2005 at 11:51:59:
Jeremy the hydraulic pump won"t need to come out, There should be 4 bolts holding a flange to the crank pulley, remove these and push the flange towrd the front of the tractor to allow the belt to slip up between the flange and the pulley. As for the water pump pulley, yes it is pressed onto the pump shaft, and unless you have a lot of experience and a large press you would be ahead to take the pump off the tractor and take it to a MF dealer and let them do the press work. Hope this helps and good luck. willy
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|